v1.0 12/15/11
8
Remove two screws from the power box
and open it.
Thread the power cable through the
waterproof head on the left and the RS485
and video cable through the waterproof
head on the right.
Connect the cables to the circuit board
and double check to ensure each cable is
connected to its proper location. Damage
may occur if cables are improperly
connected.
After all cables are connected, tighten the
two heads. It is advisable to apply
waterproof sealant to the heads.
Close the power box and tighten the bracket to the
box. Double check all bolts and screws are tight. It
is advisable to apply waterproof sealant to all joint
gaps.
After the camera is physically mounted and
installed:
Connect the camera to the monitor with a 75
Ω
coaxial video cable.
Connect power supply’s AC plug to a suitable AC power outlet.
Make an RS485 connection between the camera and the PTZ controller. Ensure
the connections at the PTZ controller and camera have the same polarities.
