V2.0 5/1412
5
System Setup DIP Switch SW1
ON = 1 OFF = 0
Baud rate setting
DIP Switch
8
7
6
5
4
3
2
1
Function
3 off, 2 off... baud =2400
3 off, 2 on... baud =4800
3 on, 2 off... baud =9600
ON and OFF are indicated on the DIP Switches to show the DIP positions.
PELCO-D and PELCO-P can be automatically recognized.
J7 pin = if jumpers 2-3 are connected with a jumper, terminal connects
to 120Ω resistance. If
jumpers 1-
2 short, terminal is not connected to 120Ω resistance.
To select the baud rate set switches 3 and 2 on the System Setup DIP Switch as described
above.
Camera Module Selection
The ST-PTZ480-22X uses a purpose-made camera
module although various other camera modules may be
compatible with the unit. The DIP switches on the
camera module’s PCB board are factory set for the
installed camera module and are not to be adjusted by
the installer or user.
5. WIRING CONNECTIONS
a. Connect the power supply cable and communications cable to the AC24V and RS485
connections on the main board as shown above.
b. Connect the camera to the monitor with a 75
coaxial video cable.
1. Power supply and
communication cable:
AC24V power supply
AC24V power RS485
2. Video output
Summary of Contents for ST-PTZ480-22X
Page 15: ...V2 0 5 1412 15 ...
