2
Welcome
Thank you for purchasing our Network camera.
This Quick Start Guide is designed to get your system up and running as easily as possible.
This document applies to both the ST-IP-MD36-1 and ST-IP-MD36-2 camera models (1mp &
2mp).
Please read the following safeguard and warnings carefully before you use this camera.
Please keep this document for future reference.
Important Safeguards and Warnings
1
．
Electrical safety
All installation and operation should conform to your local electrical safety codes.
The power shall conform to the requirement in the SELV (Safety Extra Low Voltage) and the
Limited power source is rated 12V DC, DC5V or AC24V in the IEC60950-1. (Power supply
requirement is subject to the device label).
Please prevent the line cord from being crushed or damaged, especially at the plug, power
socket and the junction from the device.
Note: Do not connect a PoE power source AND a power supply to the device at the same
time; it may result in device damage.
We assume no liability or responsibility for fires or electrical shock caused by improper
handling or installation.
We are not liable for any problems caused by unauthorized modification or attempted repair.
2
．
Environment
Don’t aim the device at strong light (such as lighting, sunlight and so on) to focus;
otherwise it may cause overexposure, which will affect the longevity of the CCD or CMOS
imager.
Please transport, use and store the device within the range of allowed humidity and temperature.
Don’t keep the device in a place which is wet, dusty, extremely hot, and extremely cold and with
strong electromagnetic radiation or unstable lighting.
Please do not allow water and other liquids to enter the camera, to prevent the internal
components from being damaged.
Please allow adequate ventilation around the camera to prevent heat accumulation.
Please pack the device with the standard factory packaging or material with the same
quality when transporting the device.
Avoid bumps and humidity during transportation, storage and installation.
