WIRING:
1. Carefully choose a hidden out-of-sight location for drilling the cable hole. Some vehicles may
have an existing hidden rubber grommet or plug available to avoid having to drill into the
body. Be sure to double-check for any wiring or obstructions behind the surface where you
are going to drill the cable hole. Use the rubber grommet to make a watertight seal for the
cable where it passes into the vehicle.
2. Choose a convenient place to run the camera cable up the left, right or center of the vehicle.
As a rule of thumb, try to avoid main factory harness looms that may contain high levels or RF
noise or interference.
3. You can connect the camera power at the rear of the vehicle behind the reverse lights. You
may also connect power inside the vehicle under the dash or in the trunk. The Red power
wire goes to Reverse Light +12V, and the Black wire to Ground.
4. Run the Yellow RCA video cable to your monitor’s video input or reverse camera input. The
White RCA cable is for audio and can be hooked up to the audio source of your monitor (If
Equipped)
5. The small white plug is for the parking assist lines. Clip on the plastic jumper cap to engage
the parking assist lines or leave it disconnected to turn them off.
Rubber Grommet
Yellow Video RCA
Power
Connector
Black
Red
+12V Reverse
Light wire
Ground
White Audio RCA
Parking Assist
Lines Jumper
MONITOR
SV-6912 CAMERA
