Nnn-0000nn
© Copyright 2012 SecureALL Corporation
Page
16
of
22
All Rights Reserved
The Power Cable is two-wire, black/red, but is attached to a four-wire connector
that goes into the socket at the top right of the PCB. The top side of the connector
is stepped, not smooth.
e. After all cables are attached, the assembly will look as shown in Figure 8e. Take
any excess wire for the Motor and Latch Position Cables and push it back through
the hole in the Inside RF Assembly to make it easier to install the Inside Cover
Assembly.
Figure 8e
9.
Insert the three AA batteries (Item 19) into the battery box in the Inside RF Assembly.
Make sure the polarity of the batteries is correct.
Figure 9
