Battery Level
Provides the current battery voltage level Battery
Command Class
Level Reports on receipt of a battery get
command.
(Battery Level Reports with parameter = 0xFF)
can be sent unsolicited to nodes in Group 3.)
Wake Up Command
Wake Up Commands are available through the
Class (Ver 2)
‘Wake Up Capabilities Report’. Default wakeup
settings will be used if the unit is not included
onto a network or has not received a valid wake
up interval.
Thermostat Mode
The only supported mode is type Heat.
Command Class
Thermostat Setpoint
The Setpoint type of 'Heating' is supported.
Command Class
The SRT323 will accept Setpoint SET commands
only if the Setpoint type is 'Heating'. SRT323 will
send a Setpoint REPORT in response to a Setpoint
GET message or unsolicited messages can be sent
to nodes in Group 4 when the set temperature is
changed locally on the SRT323.
Association
The following association groups are supported:
Command Class
Group 1 - Lifeline. The node associated to this group
will receive messages from all the other groups,
whether or not that group has itself been
associated. Only one node may be associated to
this group.
Continued on next page...
20