Page 12 of 20
BGX501-806-R02, Censeo User Manual
Public
scroll lock
When these buttons are pressed simultaneously for 5
seconds, Censeo locks the current display shown and stops
scrolling the display.
Long (5 sec)
Meter Info
When these buttons are pressed simultaneously for 5
seconds, Censeo displays meter information.
Long (5 sec)
Table 3: Available key functions in Censeo
5.6 Display
Censeo supports a maximum of 4 display pages and page 1 can show a maximum of 10 displays; each page 2
and page 3 can show a maximum of 4 parameters; page 4 can show a maximum of 2 alarm information.
Displays for Censeo are software configurable through Pump Test 9. Each key press turns the backlight on for
10 seconds, and the display reverts to the first page if no key is pressed for 30 seconds.
Each page has a defined type of displays as under –
Page
Remarks
1
This page is set up for auto scroll by default. While only one parameter is displayed at a time,
the maximum configurable auto-scroll time is 240 seconds. Up to 10 displays can be configured
for this page, and auto scroll can be stopped at desired display as shown in the Table 3.
2, 3
These pages are not set up for auto scroll by default. Up to 4 parameters can be defined for
pages 2 and 3.
4
This page is used only for alarm displays. Up to 8 alarms can be configured for parameters
shown in Table 2 out of which only 2 can be shown.
Table 4: Available display pages in Censeo
Upon every power up or pump/ hydro-turbine/ blower start, ‘dT stabilizing’ display is shown when the efficiency
calculation method is Thermodynamic, Thermodynamic method in combination of any other method or
polytropic, until dT gets stabilized. This display lasts for approximately 2 minutes if the Censeo and pump/
hydro-turbine/ blower are powered on.
If the efficiency calculation method is Lookup, Conventional or combination of Lookup and Conventional
method, then display will show ‘Stabilizing’.
5.6.1 Meter Information displays
Meter information displays last only for 5 seconds and can be activated as shown in Table 3. First page in meter
information displays shows the serial number and firmware version; second page in meter information displays
shows the power on-off count, baud rate of power meter communication port, baud rate of RS485
communication port and baud rate of the optical port.
