To Exit Programming Mode Immediately:
To Exit Programming Mode Immediately:
To Exit Programming Mode Immediately:
To Exit Programming Mode Immediately:
To Exit Programming Mode Immediately:
Press
MODE
, press
1
, then press
ENTER
. This returns the unit to normal mode
immediately, bypassing the 15 second timeout.
+ 1 +
PROGRAMMING HINTS
PROGRAMMING HINTS
PROGRAMMING HINTS
PROGRAMMING HINTS
PROGRAMMING HINTS
Password:
Password:
Password:
Password:
Password:
If the password is lost or forgotten it can be restored to the factory
default. Remove the RK600 unit from the mounting plate, disconnect power
(unplug the connector from J1 or disconnect the DC power supply) Press and
HOLD the reset switch (SW1, on the reader circuit board) restore power, then
release the switch. Note that this will also reset the latch timer and reader mode
to the factory default.
Latch Timer:
Latch Timer:
Latch Timer:
Latch Timer:
Latch Timer:
The latch timer controls the latch/alarm shunt relay. The latch
time can be changed to any value from 0.25-30 seconds. If the latch timer is set
to 0 seconds, this pulses the latch relay for 0.25 second, sufficient for most electric
turnstiles. The beeper and green LED are always fixed at one second.
Operating Mode:
Operating Mode:
Operating Mode:
Operating Mode:
Operating Mode:
Three operating modes are possible. For normal
operation select Mode 1; to temporarily lock all transponders out select Mode 2;
to hold the door open continuously select Mode 3.
BASIC OPERATION
BASIC OPERATION
BASIC OPERATION
BASIC OPERATION
BASIC OPERATION
USING RADIO KEY
®
TRANSPONDERS
To use Radio Key
®
600, simply hold your Radio Key
®
Transponder near the RK600
Unit or optional Auxiliary Reader. If the Transponder ID Number is stored in
memory, the latch relay is activated, unlocking the controlled door or gate and
shunting any external alarms. A green light and a beep indicates that access is
granted. If the Transponder ID Number is not stored in memory, the door or gate
remains locked and a red light and three rapid beeps indicate that access is
denied. Otherwise the LED is normally off.
USING KEYPAD ENTRY
For PIN entry, enter your User Number, 4-digit PIN, then press
*
.
Leading zeroes
can be omitted for the user number, but can’t be omitted for the PIN Code.
(MODE)
(ENTER)
5428
www.SecuraKeyStore.com
(800) 878-7829
