RADIO KE
RADIO KE
RADIO KE
RADIO KE
RADIO KEYYYYY
®
®
®
®
®
600
600
600
600
600
QUICK-START USER GUIDE
QUICK-START USER GUIDE
QUICK-START USER GUIDE
QUICK-START USER GUIDE
QUICK-START USER GUIDE
This guide contains keypad sequences for programming your Radio Key
®
600,
using the built-in programming keypad.
Radio Key
®
Transponders (Key Tags) are pre-encoded and engraved at the
factory with unique Transponder ID numbers. Facility Codes (Site Codes) are
not required. You may assign either a Transponder or a PIN code to each
User
Number
(1-600) for programming purposes. Be sure to record the User
Number, the Transponder ID Number or PIN code and the user’s name on the
User Log Form. A blank form has been included for this purpose. Do not write
on this form; use it as a photocopy master.
A red light and three beeps at the end of a keypad sequence means that
you have made an error.
Refer to the appropriate section, and carefully
re-enter the command in the proper sequence.
If you select a User Number for which a Transponder ID Number or PIN is
already stored in memory, a red light and three beeps will occur. Select
another User Number or void
the User Number, which removes the previously
stored Transponder ID or PIN Number from memory.
NOTE: User Number and ID Number Values in the following
examples are for demonstration purposes only; enter
the appropriate values for your system.
First, enter Program Mode:
First, enter Program Mode:
First, enter Program Mode:
First, enter Program Mode:
First, enter Program Mode:
Enter your 5-digit password, then press
ENTER
. (All new units are pre-programmed
with the password 12345.) The LED will flash amber to show that the unit is in
Program Mode.
The unit will “time out” and return to Active (Normal) Mode in 15
seconds if no key is pressed.
1 + 2 + 3 + 4 + 5 +
Add a Transponder (Key Tag) to the System:
Add a Transponder (Key Tag) to the System:
Add a Transponder (Key Tag) to the System:
Add a Transponder (Key Tag) to the System:
Add a Transponder (Key Tag) to the System:
Enter Password.
Press
ENTER.
Press
ADD
. Enter a User Number (1- 600) and press
ENTER.
The example is for User #12. Hold the Transponder near the RK600 Unit. A green
light and beep means the Transponder was accepted. A red light and three beeps means
a Transponder or PIN has already been stored for the selected User Number. Delete the
previously stored Transponder or PIN or select a new User Number.
+ 1 + 2 +
(Hold Key Tag near unit)
(User Number 12)
(Password)
(ENTER)
(ADD)
(ENTER)
