+AUX
COM
AC
BAT
-PGM1
-PGM2
20V
COM
Z1
Z2
Z3
Z4
Z5
X
1
Z6
U
SB
S1
S2
+BELL
G
S
V
4
Wiring of LED and system status indication
GSV4
+AUX -PGM2
+
A
U
X
-P
G
M
2
1
k
Ω
Typical system installation example
Key-switch zone wiring
Additional information (continued)
GSV4 zone definition is
PGM control
, which can be used to connect a key-switch. It is possible to program this zone to arm the system when the zone is violated and
to disarm and clear the alarm when the zone is restored.
Images below show an example of how to connect and program the key-switch zone. The zone input is programmed to arm the system in
Away
mode when the zone
is violated (NC) and to disarm the system when the zone is restored (NO). If there is an alarm in the system,it will be cleared when disarming.
Zone settings:
GSV4
Z
6
C
O
M
Z6 COM
Wiring:
Turned Off
Turned On
System is disarmed
System is armed in
Away
mode
Operation:
GSV4 PGM definition is
Full arm status
, which can be used to indicate the system status (armed/disarmed). In this example, LED is used to show the status. The
system turns LED on when it is armed and turns it off when the system is disarmed.
Wiring:
PGM settings:
Operation:
Normally open
contact
(NO)
Normally closed
contact
(NC)
System is armed
System is disarmed
Intruder alarm system
GSV4
Wiring manual
12V battery
7Ah/20HR
Page 4
Rev.08/09/16_KF
