®
Electromagnetic Lock
E-941Sx-600
/
E-941Sx-1200
Manual
Identification of: NFPA Standards 70 and 72
Model
Holding Force
Material
Color
E-941SA-600
600-lb (272kg)
Anodized Aluminum
Aluminum
E-941SA-1200
1,200-lb (545kg)
Anodized Aluminum
Aluminum
E-941SB-600
600-lb (272kg)
Anodized Aluminum
Black
E-941SB-1200
1,200-lb (545kg)
Anodized Aluminum
Black
E-941SD-600
600-lb (272kg)
Anodized Aluminum
Dark Bronze
E-941SD-1200
1,200-lb (545kg)
Anodized Aluminum
Dark Bronze
5NR4
Use only Hardware provided with these products for mounting. Door thickness should be 1
3
/
4
" thick, otherwise different
sex nut will be required. Door Header shall be minimum 2
3
/
4
" thick and flat surface is needed to securely mount screws
for magnet, may need filler plates or angle bracket to mount magnet correctly.
WARNING
!
Warnings indicate potentially hazardous
conditions, which if not avoided or corrected
may cause death or serious injury
NOTICE
Notices indicates a condition that may cause
equipment or properly damage only.
NOTICE
!
CAUTION
Cautions indicate potentially hazardous conditions, which if not
avoided or corrected, may cause minor or moderate injury.
Cautions may also warn against unsafe practices.
!
CAUTION
The electromagnet lock requires a
face-to-face fitting as shown in figure
otherwise, the holding force will be
greatly decreased (direction of
hydraulic press pull must be collinear).
!
CAUTION
Remove any diode installed across the
magnetic lock for spike suppression.
The magnet is fitted with a metal oxide
varistor to prevent back EMF.
