To reset the HPC01 controller to factory settings, press the
and
buttons simultaneously for 3 seconds.
Setting the temperature:
Briefly press
, the symbol in the display starts flashing. The value in the display
changes from the current ACTUAL value to the TARGET value, which can now be set.
Turn clockwise to increase the TARGET temperature, counterclockwise to decrease. Press
the rotary knob or press
to store the
set value. If no input occurs for 5 seconds,
input mode ends automatically. Pressing
exits input mode, the set value is not
applied and the display returns to the current ACTUAL value.
Temperature-related indicators:
is activated whenever the heater is running.
During the warm-up phase, every 10s an estimated remaining warm-up time scrolls across
the display for 3s instead of the current temperature.
is activated when the CURRENT temperature corresponds with the TARGET
temperature, allowing for a certain deviation of X°.
Arrow up is activated when the temperature is rising (if below TARGET
temperature, arrow is blinking), arrow down is activated when the temperature is dropping,
e.g. during a transfer or if the heat plate is still hotter than the set target temperature.
is generally activated in the event of faults or errors, and when there is a significant
deviation between TARGET and CURRENT temperature (value outside of a range that
allows for pressing).
Setting the time
(irrelevant for the TB7, time is controlled by the heat press)
:
push briefly, symbol in the display flashes. Turning the rotary knob clockwise
increases time, counter-clockwise decreases. Press the rotary knob or press
to
Secabo GmbH Hochstatt 6-8 85283 Wolnzach Germany [email protected] www.secabo.com
