sPress2 Fingerprint
Standalone Access Control User Manual V1.0
Sebury Technology Co., Ltd
http://www.sebury.com
20
4.3Users operation
4.3.1 Get user card or enter Fingerprint
Users must obtain the user card or entering fingerprint from the administrator for the
first time.
4.3.2 4.3.2 User open door
Open door by user card or fingerprint:
read user card, or fingerprint.
Open door by user card and fingerprint:
Read user card, press the user’s fingerprint in 5 seconds.
Open door by multi-users:
Read user card (or fingerprint), read another user card (or fingerprint) in 5 seconds ….
Exit operation:
Press exit button
Note: In addition to the exit operation, make sure that the machine is not in a disable
user state. You must first set up good way to open the door, open the door by multi-card
also needs to set a good quantity of card. If card or PIN is valid, a long “beep”, the lock will
be opened. During the opening time, LED turns green. After that, LED turns red and keep.
In card & PIN open mode or multi-card open door mode, the interval time of reading card
or inputting PIN cannot be more than 5 seconds.
4.4 Other operations
4.4.1 Cancel alarming
Read admin card (or fingerprint) or the user card (or fingerprint), or Admin Password #.
Note: When the alarm has happened, the buzzer will ring "Wu, Wu" alarm sound. User
can cancel the alarm by reading the valid user card (or fingerprint) and entering Admin
Password. But the alarm output signal can’t be canceled by reading the anti-duress card.
4.4.2 Admin Password initialization
When you forget the Admin Password, you can restore it to the initial password by
special operation. Operation is as follows:
Power off, and then power on again, press # key in one second within the indicating light
turn orange, then you will hear two “beep”, and a long beep, admin password has restored
to 888888. But the other parameters, the info of the card and fingerprint will be still kept.
4.4.3 Restore factory settings
