the machine and securely seated over the projection tab (23). Insert an attachment tool, if desired,
onto the end of the flexible hose. You may also release the hose while the attachment tube is
disengaged from the machine by pressing the release button (2) at the base of the handle (11). While
using attachment tools, if the the power head brush roller is not able to disengage from the floor
surface, you may keep the brush roller off the car- pet by placing the handle (1) in its upright locked
position and lowering the handle with one hand to raise the brush roller off of the floor. Operate
attachment accessories with the other hand. Or, with the handle in the upright locked position, the
machine may be tipped backward so that it rests on the back side of the bag housing (6), and the power
head is locked in a perpendicular position to the floor.
To vacuum walls, under beds, or higher-reach areas, etc., the SEBO
essential G can be fitted with an additional straight tube (45) and the
wall and floor brush (41). The machine will then perform as a canister
vacuum (as shown in figure 3).
The Display Panel - Figure 7
Red
Light
Description
A
Off � Operation of machine is normal
A
Continuous � change bag or clear clog in the hose or
power head.
A
Flashing and motor off � dust bag is full, or clog in the
hose or power head due to ignoring the continuous red
warning light for full bag or clog (see above)
B
Off � Operation of brush is normal
B
Continuous while in position 1 on the pile adjustment
knob (18) � brush is worn -change brush roller
B
Continuous while in positions 1-4 � incorrect brush
setting - adjust the brush by turning the pile adjustment
knob (18) to a higher or lower position
B
Flashing and motor switched off � clogged brush
B
Flashing and motor switched off with no blockage � raise
brush to a higher position
The pile adjustment wheel (18) has 4 brush height settings. Setting 1 is
the lowest brush setting and setting 4 is the highest brush setting. When
starting the vacuum, always start with the knob set at 4, then lower knob
settings until the brush reaches the proper height. The red brush light on
the display panel will light after 6 seconds if the brush is too high. Adjust
the knob down. If after 6 seconds, the brush light stays unlit, the brush
is at the proper setting for the pile. The red brush light will also illuminate
if the setting is too low. Adjust the knob up until the light stays unlit after
6 seconds.