7
Starting The Machine - Figures 5 & 6
Before turning on your vacuum cleaner with the DISCO attached, make sure that
the vacuum handle is in its upright locked position and that you have a firm hold
on the handle grip to keep the machine from moving forward.
Make sure that the ON/OFF Switch (19) of your SEBO FELIX (figure 5) or SEBO
C3.1 or K3 (figure 6) is in the OFF position.
Switch Position
O = OFF
I
= ON
Release the power cord from the cord hook or reel and plug the polarized power
cord into a 120 volt outlet located near the floor.
Press the power switch to the ON position.
Operating the Machine - Figures 7 & 8
NOTE:
The SEBO DISCO has a soft-start system, so there may be a slight delay
before it operates.
When the machine is switched on with the handle in the upright locked position,
the DISCO pad will automatically raise from the floor and will stop spinning. To
release the polisher from the upright locked position, press down on the foot
pedal (7) and lower the handle into the normal operating position. The DISCO pad
will automatically lower to the appropriate height and will start spinning.
When finished, switch the machine off and remain holding the vacuum cleaner
firmly until the floor pad stops rotating. Then, return the handle to its upright,
locked position.
19
7
5
Figure 5
Figure 7
Figure 6
19
Figure 8
5
7
Figure9
8
LED Display - Figure 9
The green LED light (9) indicates that the floor polisher is powered on and opera-
tional.
If the air flow pathway becomes restricted due to a clog or a full bag, the red LED
light (8) will illuminate and the machine will shut off. If this occurs, turn the power
switch off, unplug the machine and immediately check for clogs in the DISCO head
(see “Clog Removal” on page 8). If no clog is found, check for clogs in the vacuum
cleaner or for a full dust bag. Refer to your vacuum cleaner owner’s manual.
9
All manuals and user guides at all-guides.com
