Preparatory Work in the Office
20
As soon as the SIM card has been inserted, the device should be programmed with the
necessary GSM connection data so that a GSM connection test can be carried out.
Additional information on programming the GSM transmitter and on the GSM connection
test can be found in the following sections.
4.3
Connecting the wireless interface to the PC/laptop
In order to communicate with the GSM transmitter, you will need to connect a wireless
interface to the computer (see page 10).
4.4
Creating a logger group in the SebaDataView-3 software
A group must be created in the SebaDataView-3 software (or SDV-3 for short) on the
PC/laptop which contains all loggers to be used, or which could be used, for the
forthcoming measurement.
You can create a new group for this purpose, or you can add the loggers in question to
an existing group.
Please note:
Use of the GSM transmitter is
possible in combination with
•
Log P-3 pressure loggers
•
Log N-3 noise loggers in the "Lift&Shift" group mode
Use of the GSM transmitter is
not possible in combination with
•
Log N-3 loggers in the "Patrol" group mode
•
Log N-3 loggers in "Network" group mode
To create a new logger group, proceed as follows:
Select the required zone in the directory tree for the SDV-3, open the
Directory
register,
click on
New
in the
Group
segment and create a new group.
To add the required loggers to the group, proceed as follows:
Select this group in the directory tree, open the
LogP
or
LogN3
register in the menu
bar, click on
New
in the
Administration
segment and then register the loggers one by
one.
Detailed information on creating and managing logger groups in the SDV-3 can be
found in the user manual for the logger in question.
Testing the GSM
connection
Restriction
Procedure
