Seat Toledo 2019, Owner'S Manual

Page: 112 / 300

Operation
Replacing the battery in the remote
control key
Fig. 119
Vehicle key: opening the battery com-
partment.
Fig. 120
Vehicle key: removing the battery.
SEAT recommends you ask a specialised
workshop to replace the battery.
The battery is located to the rear of the vehi-
cle key, under a cover.
Changing the battery
●
Unfold the vehicle key shaft.
●
Remove the cover from the back of the ve-
hicle key
›››
Fig. 119 in the direction of the ar-
row
›››
.
●
Extract the battery from the compartment
using a suitable thin object
›››
Fig. 120 .
●
Place the new battery in the compartment
as shown
›››
Fig. 120 , pressing in the opposite
direction to that shown by the arrow
›››
.
●
Fit the cover as shown
›››
Fig. 119 , pressing
it onto the vehicle key casing in the opposite
direction to that shown by the arrow until it
clicks into place.
CAUTION
●
If the battery is not changed correctly,
the vehicle key may be damaged.
● Use of unsuitable batteries may damage
the vehicle key. For this reason, always re-
place the dead battery with another of the
same voltage, size and specifications.
●
When fitting the battery, check that the
polarity is correct.
For the sake of the environment
Please dispose of your used batteries cor-
rectly and with respect for the environ-
ment.
Note
If it is not possible to unlock or lock the ve-
hicle with the remote control key once the
battery has been replaced, it will need to
be re-synchronised
›››
page 109 .
Central locking system
General notes
All of the doors, the rear lid and the fuel cap
flap 1) will unlock at the same time when the
central locking system is used.
Warning lamp on the driver door
Once the doors are locked, the warning lamp
will flash quickly for 2 seconds and then at a
slower rate.
If the vehicle is locked with Safe lock engag-
ed
›››
page 112 , the warning lamp on the
1) Valid for vehicles with a keyless fuel tank cap.
110