INSTALLATION STEP 6
Install Light and Lens:
15
Install a 75 watt maximum light bulb in socket. Light
will turn ON and ramain lit for 4-1/2 minutes when
power is connected. Then light will turn OFF.
If bulb burns out prematurely due to vibration,
replace with "Garage Door Opener' bulb.
INSTALL LENS: Slide lens into guides as shown.
Snap bottom tabs into lens slots. For convenience,
lens may be installed after adjustment Step 3 on
Page 22.
Lens Guide
Lens Slot
75 Watt Max.
Light Bulb
Lens Tab
Light Lens
INSTALLATION STEP 7
Attach Emergency Release
Rope & Handle
USE EMERGENCY RELEASE ROPE
ONLY TO DISENGAGE TROLLEY.
DO NOT USE ROPE AND HANDLE
TO PULL DOOR OPEN OR CLOSED.
PROCEDURE: Thread one end of rope through hole
in top of red handle so "NOTICE' reads right side up
as shown. Secure with an overhand knot.
NOTE: Knot should be at least 1" from the end of the
rope to prevent slipping.
Thread other end of rope through hole in release arm
of outer trolley. Adjust rope length so that handle is 6
feet above the floor. Secure with an overhand knot as
above.
NOTE: If it is necessary to cut rope, heat seal cut end
with a match or lighter to prevent fraying and/or
raveling.
Trolley
NOTICE
Overhand
Knot
Emergency
Release Handle
Rope
Overhand
Knot
Trolley
Release Arm