8
Safety Information
• Install the light in compliance with the effective local electrical code(s).
• Mains power should always be disconnected when work is being done in close proximity to
electrical fittings, and electrical work should only be done by a licensed electrician.
• Operate the light only within the indicated electrical ratings and product usage instructions.
• To ensure that the light and peripheral equipment function safely and correctly, use cable in
compliance with the effective local electrical code.
• Do not stare at the LED or shine the LED into your eyes or those of another person.
• Do dispose of the product according to the local laws and regulations for your region, for example,
at a recycling centre that accepts electronic devices.
Unpacking, Installation, Wiring & Setup
Unpacking
Unpack all hardware and inspect for damage. If there is any damage, please contact your Sealite
Office. Retain original packing material for possible future use in shipping.
Installation & Wiring
Before proceeding with installation or service, make sure the following conditions are met:
• Ensure the tower or mast is grounded (NO RF HAZARD)
• Check the mast lighting circuit is not faulty
• Ensure power lines are not ‘live’ (NO ELECTRICAL HAZARD)
• Avoid touching live circuits!
NOTE:
• Make sure the mounting pole is vertically aligned to guarantee the required beam pattern of the
bridge light
• Make sure the light’s beam pattern is not disturbed by any nearby obstacles
• Ensure the cable gland is tightly sealed around the cable
