background image

Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR

 01284 757500 

 01284 703534 

 [email protected] 

 www.sealey.co.uk

ENVIRONMENT PROTECTION

Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to 
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely 
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids 
according to local regulations.

Note

: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior 

notice.

Important

: No Liability is accepted for incorrect use of this product.

Warranty

: Guarantee is 12 months from purchase date, proof of which is required for any claim.

Original Language Version

© Jack Sealey Limited

SX299.V2      Issue 1     07/01/20

Summary of Contents for SX299.V2

Page 1: ...ool if you are tired or under the influence of alcohol drugs or intoxicating medication 9 Maintain the tool in good condition 9 Follow all workshop safety rules regulations and conditions 9 Wear eye protection protective gloves and safety footwear 9 Maintain correct balance and footing Ensure the floor is not slippery and wear non slip shoes 9 Keep children and non essential persons away from the ...

Page 2: ...hroud over the tool body the outer shroud should protrude 5mm ahead of the tips of the blade to provide a shield to the lock nut This will provide protection to the wheel The lock nut stud and the blade are all inside the outer shroud 6 5 Fit the hand protection ring over the end of the tool WARNING Blades A and B must not be used on hardened nuts or studs 6 6 Use the centre punch provided to test...

Page 3: ...the tools slips re cut and try again NOTE It is possible to support the tool with a small scissor jack Use the assistance of a second person to push down on the bar The other person pushes the tool into the locknut 7 OPERATION BLADE C 7 1 Blade C is designed to remove the type of hardened nut shown in fig 8 7 2 Blade C is designed to remove two sizes of lock nuts Select the end that is a best fit ...

Page 4: ...en the product becomes completely unserviceable and requires disposal drain any fluids if applicable into approved containers and dispose of the product and fluids according to local regulations Note It is our policy to continually improve products and as such we reserve the right to alter data specifications and component parts without prior notice Important No Liability is accepted for incorrect...

Reviews: