WARNING!
Ensure Health & Safety, local authority and general workshop practice regulations are adhered to when using
this equipment.
WARNING!
Disconnect from the air supply before changing the suction cups, servicing or performing any maintenance.
Maintain the puller in good condition (use an authorised service agent). Before each use check condition of tool. If any
component is worn or damaged, replace immediately. Use genuine parts only. Unauthorised parts may be dangerous and
will invalidate the warranty.
DO NOT
operate the puller if any parts are damaged or missing as this may cause failure and/or personal injury.
Use in a suitable work area. Keep area free from unrelated materials and ensure that there is adequate lighting.
WARNING!
Always wear approved eye (or face) and hand protection when operating the puller.
Remove ill fitting clothing, ties, watches, rings, other loose jewellery and contain and/or tie back long hair.
Keep air hose away from heat, oil and sharp edges. Check air hose for wear before each use and ensure that all
connections are secure.
WARNING!
Ensure correct air pressure is maintained and not exceeded. Working pressure is 90psi.
DO NOT
attempt to attach the suction cup to a person as severe bruising and/or damage to internal organs can occur.
DO NOT
place air line attachments close to your face and do not point at other people or animals.
DO NOT
direct air from the air line at yourself or others.
DO NOT
carry the puller by the hose, or yank the hose from the air supply.
Maintain correct balance and footing.
DO NOT
over reach, ensure the floor is not slippery, wear non-slip footwear.
Keep children and unauthorised persons away from the working area.
Ensure workpiece is secure before operating the puller.
DO NOT
operate the puller when you are tired or under the influence of alcohol, drugs or intoxicating medication.
DO NOT
clean the suction cups with solvents or other harsh chemicals.
DO NOT
use the puller for any purpose other than that for which it is designed.
When not in use disconnect from air supply, return parts to the case, and store it in a safe, dry, childproof location.
InStRUCtIonS foR:
AIR SUCTION DENT PULLER
MoDEl n
o
:
RE101.V2
thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions and properly
maintained, give you years of trouble free performance.
1. SAFETY INSTRUCTIONS
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/
OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
2. DESCRIPTION
Air activated suction pad keeps firm hold of panel while slide hammer is used to ease out dents and depressions without damage
to the paint surface. Ideal for initial panel reshaping. Supplied with Ø75mm, Ø100mm and Ø125mm suction pads and hook.
Original Language Version
RE101.V2 Issue: 1 - 16/08/12
© Jack Sealey limited
