masking tape dispenser step - up
1 x 450mm roll
mODEL NO:
mk64
thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. saFetY
9
9
99
Ensure the dispenser is on a flat, level floor before loading or
9
using the dispenser as a step-up working platform.
9
9
99
Be aware that the serrated paper cutting blade is sharp - handle with extreme care.
9
8
99
do not
use the dispenser for any purpose other than that for which it was designed.
2. introduction
Single roll dispenser accepts rolls up to 450mm. Features a step-up working platform. Automatically applies adhesive tape to edges of masking
paper.
3. speciFication
model no: ......................................................................mK64
Capacity: ........................ 1 x 450mm paper roll (not included)
4. contents
5. assemblY
5.1.
Lay the Top Platform (1) onto a protected surface with the
rubber pad, face downwards.
5.2.
Place an end frame (2) upside down, at one end of the
platform and align the holes in the frame with the holes in the
upturned platform edge. Drop a washer (14) onto each of two
m6 x 40mm bolts (12) and insert the bolts through the aligned
holes from the outside of the top platform. Slide another
washer (14) over the end of each bolt, followed by an m6 nut
(13) and do the nut up, hand tight only at this stage.
5.3.
Fix the second end frame (2) to the other end of the platform in
the same way, ensuring that the holes in each frame for
mounting the cutting bar (3) are both on the same side of the
platform.
Refer to
instruction
manual
Original Language Version
© Jack Sealey Limited
part .............description .............................................no oFF
1
.................Top platform .......................................................1
2
.................End frames .........................................................2
3
.................Cutting bar ..........................................................1
4
.................Paper spring .......................................................1
5
.................Paper mounting tube ..........................................1
6
.................Threaded fixing knobs ........................................2
7
.................Nylon stops ........................................................2
8
.................Springs ...............................................................2
9
.................Large washer (Ext.Ø44mm) ...............................2
10
................Rubber
feet ........................................................4
11
................Cross brace tube ................................................1
12
................Frame fixing bolts (m6 x 40mm) ........................8
13
................Frame fixing nuts (m6) ......................................6
14
................Frame fixing washers (m6, ext.Ø12mm) ...........18
15
................masking tape reels .............................................2
16
................Reel fixing bolts (m6 x 80mm) ...........................2
17
................Butterfly nuts (m6) ..............................................4
18
................Tubular sleeves ..................................................2
19
................Sleeve washers (m6, ext.Ø14mm) .....................4
fig.1
fig.2a
fig.2b
mK64 | Issue:3 (H,F) 02/10/19
