background image

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, 

and properly maintained, give you years of trouble free performance.

LP14.V2 Issue: 6 (ERP) - 31/07/19

Original Language Version

© Jack Sealey Limited

Hot surface

THIS PRODUCT IS NOT SUITABLE FOR PRIMARY HEATING PURPOSES.

1.  SAFETY 

 

IMPORTANT: 

The LP14.V2 is a mobile, propane-fired, unvented, infrared space heater for commercial applications only. It is designed for  

 

use with Propane cylinders of between 7kg to 15kg gas capacity.

 DO NOT 

use domestically.

 

‰

  

WARNING!

 

Use only in well ventilated spaces of more than 15m³ to prevent an accumulation of dangerous combustion gases.

 

8

  

DO NOT

 operate heater in basements or otherwise below ground level, in high rise flats, bathrooms or bedrooms.

 

8

  

DO NOT 

operate heater in leisure vehicles such as caravans and autocaravans.

 

‰

  

WARNING! Heater will become very hot during use.

 

‰

  

WARNING!

 

Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this equipment.

 

9

   Familiarise yourself with the application and limitations of the heater, as well as the potential hazards.

 

‰

  

WARNING!

 

Disconnect the heater from the gas supply before performing any maintenance.

 

9

  

Maintain the

 

heater in good condition (use an authorised service agent).

 

9

   Replace or repair damaged parts. 

Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.

 

‰

  

WARNING!

 Keep all guards and holding screws in place, tight and in good working order. The guard on this appliance is to prevent risk  

  of fire or injury from burns and no part of it should be permanently removed. 

IT DOES NOT GIVE FULL PROTECTION FOR YOUNG  

  CHILDREN OR THE INFIRM.

 Check regularly for damaged parts. A guard or any other part that is damaged must be repaired or    

  replaced before the heater is next used. Avoid twisting the regulator’s flexible tube. The tube should be inspected for damage regularly  

  and replaced if damage is found. Refer to the tube for its specification and length.

 

9

   Keep gas hose away from heat, oil and sharp edges. Ensure that all connections are secure.

 

9

   Keep the heater clean for best and safest performance.

 

9

   Ensure the propane bottle is in a stable upright position before igniting the heater. 

DO NOT

 use with the bottle in any position other than   

 upright.

 

8

  

DO NOT

 use any fuel other than propane.

 

9

   Ensure there are no flammable or combustible materials within 2 metres of the heater and that nothing, including walls, is less than    

  500mm from any surface of the heater.

 

8

  

DO NOT

 use the heater where there are flammable liquids, solids or gases such as paint solvents, etc.  

 

‰

     WARNING! NOT

 to be used for the heating of habitable areas of domestic premises: for use in public buildings, refer to national  

 

 regulations. 

 

 

‰

     WARNING! DO NOT

 use in basements or areas below ground level.

 

8

  

DO NOT

 move the heater when it is operating.

 

8

  

DO NOT

 use the heater for any purpose other than that for which it is designed.

 

8

  

DO NOT

 operate the heater if any parts are damaged or missing as this may cause failure and/or personal injury.

 

8

  

DO NOT

 adjust, or tamper with, the regulator.

 

8

  

DO NOT

 allow untrained persons to operate the heater.

 

8

  

DO NOT

 operate the heater when you are tired or under the influence of alcohol, drugs

 

or intoxicating medication.

 

9

  

When not in use disconnect from the gas supply and store in a safe, dry, childproof area.

 

9

  

In the event of a gas leak immediately close the bottle valve, extinguish any flame and 

 

then place equipment in a well ventilated area, preferably outdoors, and away from any 

 

heat sources (including strong sunlight). Rectify cause of leakage.

2.  INTRODUCTION

 

Ceramic plaque type heater. Steel tube stand with built-in handle. Heat output from 

 

10,250 to 15,354Btu/hr. Supplied with 37Mbar fixed regulator and 1.5mtr hose.

 

Fully CE approved. Gas bottle not included.

3.  SPECIFICATION

Model No.

 ...................................................................

LP14.V2

Fuel. ............................................................................Propane

Output. ......................................................10,250-15,354Btu/hr

Fuel Consumption. ...........................................  0.22-0.33kg/hr

fig.1

IMPORTANT:

 PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE 

THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR 
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.

Refer to instruction 

manual

15,354BTU/HR SPACE WARMER® 

PROPANE HEATER WITH STAND

MODEL NO: 

LP14.V2

Summary of Contents for LP14.V2

Page 1: ... that all connections are secure 9 9 Keep the heater clean for best and safest performance 9 9 Ensure the propane bottle is in a stable upright position before igniting the heater DO NOT use with the bottle in any position other than upright 8 8 DO NOT use any fuel other than propane 9 9 Ensure there are no flammable or combustible materials within 2 metres of the heater and that nothing including...

Page 2: ...es of the heater and that nothing including walls is less than 500mm from any surface of the heater Always ensure that the heater is facing away from the gas bottle 6 2 Lighting heater Refer to fig s 2 3 6 2 1 Open the gas bottle valve 6 2 2 Push the heater control dial down and turn it clockwise to the full on position and keep it held down 6 2 3 After a few seconds bring a flame up to the bottom...

Page 3: ...t up procedure again Allow to cool before restarting Move appliance away from draughts Replace the thermocouple Contact your Sealey stockist Replace the valve Contact your Sealey stockist Heater will not light Gas cylinder valve is closed Volume control not opened fully when attempting ignition Insects inside the burner Turn on the gas cylinder control check for leaks Read instructions 6 2 ignitio...

Page 4: ...rature control Yes No plus week timer Other control options multiple selections possible Room temperature control with presence Yes No detection Room temperature control with open Yes No window detection With distance control option Yes No With adaptive start control Yes No With working time limitation Yes No With black bulb sensor Yes No Information requirements for gaseous liquid fuel local spac...

Reviews: