background image

7. MAINTENANCE

  

WARNING 

If fuel remains in the tank, tilting of the mower may cause fuel leaks. Avoid fuel leaks on plastic and rubber parts.

7.1. Maintenance

7.1.1.  Ensure all fixings are tight and secure.

7.1.2. Replace any damaged or worn parts immediately.
7.1.3. Check blade during and after each use, see section 5.3.2. for removal. Blade symmetry is essential for balance.
7.1.4.

Check the cable clip and cable run, especially the throttle cable for fraying.

7.1.5.

Check the pull cord for wear and retaining handle knot integrity.

7.1.6.

Check the stone guard and grass box for integrity.

7.1.7.  There are no customer serviceable parts other than the blades and frame fixings, use qualified service personnel for all other aspects of  

 maintenance.
7.1.8.

If the fuel tank has to be drained, this should be done outside and the engine should be cool.

7.2. 

Cleaning 

  

WARNING 

If fuel remains in the tank, tilting of the mower may cause fuel leaks.

7.2.1.

After each use, clear accumulated grass cuttings from inside cutter deck. 

DO NOT 

allow the grass to dry on the mower.

 Note! 

Inside cutter deck will lose the protection of the paint finish over time. Use a rust resistant paint to repair.

7.2.2.  Clear any accumulated grass cuttings from the area of the engine, with caution around finely balanced springs and linkages.

7.2.3. Clean any grass cuttings from the wheels and bell crank axles.

7.2.4.  Clean the mower externally before storing with special attention to grass box woven mesh, which could affect airflow and grass 

 

collection rate.

8.   WARNING SYMBOLS  

The mower should be used with due care. Symbols placed strategically on various parts of the machine reminds the user of the main 
precautions to be taken at point of operation. Symbols and meanings are listed below. These meanings also add emphasis to the safety
regulations and safety information given in earlier sections of these instructions. Some warnings in the instructions may appear more than once.

NOTE:

 This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of 

experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible 
for their safety. Children should be supervised to ensure that they do not play with the appliance.

  

WARNING: DANGER! 

Refuel engine outdoors only, using a funnel

.

If fuel is spilled, move the mower away avoiding creating any   

 

source of ignition until the fuel is evaporated and dispersed. Never remove the fuel cap or add fuel while the engine is running or engine

 

is hot. Replace fuel caps immediately and securely. 

7

DO NOT 

operate the engine in a confined space where dangerous carbon monoxide fumes can collect.

7  

DO NOT

 run with mower.

7  

DO NOT

 mow slopes greater than 20°.

7  

DO NOT

 adjust any settings, links, cables etc..

7  

DO NOT

 Pick up the mower with engine running. 

The operator or user is responsible for accidents or hazards occurring to other people or their property.

6.1

With the instructions to this stage read, the mower assembled, assembly integrity inspected, cutter height set, fuel tank filled and oil    

level checked the engine is ready to be started. For engine running see separate instructions

6.2.

 The mower engine will only start with the throttle safety lever gripped (fig.7) against the upper handle frame with one hand, leaving the 

other hand free to pull the recoil cord handle (item 8). The mower cutter face must be down on a flat surface with no obstacles, stone   

 

guard down or grassbox fitted. Pump fuel primer three times. See the engine manufacturers' manual for pull cord starting. 

6.3.

 

With the motor running at full speed mowing the lawn can proceed.

6.4.

 Release your grip on the throttle lever to stop the motor. The blade will rotate for a few seconds after the motor has stopped.

6.5.

If leaving unattended, disconnect spark plug lead. If finished using, disconnect spark plug lead and go to section 5 for maintenance and

 cleaning.

6. OPERATION

GL109           Issue No: 1 -15/04/15

Original Language Version

© Jack Sealey Limited

Direction of rotation arrow
visible on blade.

fig.6.

Retaining
bolt

Warning! Danger!

Keep others away at least 10 metres.

Caution, blade will continue to rotate after the motor 
has been switched off.

Keep others away from the danger area.

fig.7

Summary of Contents for GL109

Page 1: ... 3 Ensure the mower is in good order and condition before use If in any doubt mechanically do not use the unit and contact a service agent 3 Maintain the mower in good condition and replace any damaged or worn parts Use genuine parts only Unauthorised parts may be dangerous and will invalidate your warranty 3 Inspect the lawn prior to cutting removing obstructions including molehills 3 Keep childr...

Page 2: ...grass box fig 4 Hook grassbox frame over spindle 5 ASSEMBLY GL109 Issue No 1 15 04 15 Original Language Version Jack Sealey Limited 5 3 Blade fitting 5 3 1 Decide on the grass cutting length required a choice of 8 are available from 20mm to 70mm approximate grass length settings In fig 5 a lever adjusts mower cutting height Pull the lever crank from the notch and sweep the lever to desired height ...

Page 3: ...ry or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety Children should be supervised to ensure that they do not play with the appliance WARNING DANGER Refuel engine outdoors only using a funnel If fuel is spilled move the mower away avoiding creating any source...

Page 4: ...d to be 0 7mm to 0 8mm Engine overheats Cooling air flow is restricted Incorrect spark plug fitted Remove debris from all cooling air flow passages and improve cleaning and maintenance regime Fit new correct spark plug with correct gap Mower vibrates abnormally Blade fixing has worked loose Blade is damaged affecting symmetry Stop engine immediately Tighten blade tightening torque approximately 30...

Reviews: