4.10.
starting the engine
4.10.1.
t
urn the ECS switch to “OFF” fig.10.
4.10.2.
t
urn the fuel cock knob to “ON” fig.11.
4.10.3.
t
urn the engine switch to “ON” fig.12.
4.10.4.
P
ull the choke knob fully out fig.13. (The choke is not
required to start a warm engine.)
4.10.5.
Grasp the carrying handle to prevent the generator
from falling over. Pull slowly on the recoil starter until
it is engaged, then pull it briskly fig.14.
4.10.6.
After the engine starts, let the engine warm up until
the engine does not stop when the choke knob is
returned to the original position fig.15.
4.11.
stopping the engine
4.11.1.
turn off any electric devices.
4.11.2.
turn the ecs to “off”
4.11.3.
disconnect any electric devices.
4.11.4.
turn the engine switch to “stoP”
4.12.
alternating current (ac) connection
4.12.1.
turn off all electrical devices before plugging them in.
4.12.2.
ensure total load is within generator rated output.
4.12.3.
ensure generator is earthed if any of the electrical devices are earthed.
4.12.4.
start the engine.
4.12.5.
turn the ecs to “on”.
4.12.6.
Plug device into socket and make sure Ac pilot light is on.
4.12.7.
turn on electrical device.
4.13.
Battery charging
4.13.1.
General safety
the generator dc rated voltage is 12V.
Before starting to charge the battery, make sure that the dc protector is turned on.
4.13.2.
start the engine.
4.13.3.
connect the red battery charger lead to the positive (+) battery terminal.
4.13.4.
connect the black battery charger lead to the negative (-) battery terminal.
4.13.5.
turn the ecs to “off” to start battery charging.
4.13.6.
charge the battery using the correct procedure laid down by the battery manufacturer’s instructions. follow the instructions to
determine the end of battery charging, this may include measurements of specific gravity at regular intervals.
Do not
over charge
battery.
Warning!
“modern vehicles contain extensive electronic systems. You are required to check with the vehicle manufacturer, for any
specific instructions regarding the use of this type of equipment on each vehicle. No liability will be accepted for damage / injury, where
this product is not used in accordance with all instructions.”
4.13.7.
the dc protector turns off automatically if current is above the generator rating. to restart charging the battery, turn the dc protector
on. if the protector turns off again, stop charging the battery immediately.
fig.10
fig.11
fig.12
fig.13
fig.14
fig.15
electrical
shock
hazard
Wear eye
protection
Wear protective
gloves
Warning
corrosive
substance
Keep away
from sources of
ignition
use in well
ventilated areas
Keep in dry area
protect from rain
G
I2300,GI3500 Issue 2 (fig1) 19/04/18
Original Language Version
© Jack sealey limited
