InstructIons for:
camber, castor & KIng-PIn gauge
model no:
ga450
thank you for purchasing a sealey product. manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
1. SAFETY INSTRUCTIONS
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS.
USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE
DAMAGE OR PERSONAL INJURY, AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
2. INTRODUCTION & SPECIFICATION
robust magnetic gauge mounts onto wheel/hub for quick accurate measurement of camber, castor angle, and kingpin inclination.
camber gauge with fixed graduation from +5 to -5.
adjustable caster gauge gra11 to -3.
Kingpin gauge graduated from 0 to 14 left to right.
only suitable for vehicles fitted with steel wheels.
to be used in conjunction with steering turntables and rear wheel level plates.
supplied in tough composite carry-case.
WARNING!
Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this
equipment.
maintain the
gauge in good condition (use an authorised service agent).
replace or repair damaged parts.
WARNING!
use the gauge on level and solid ground.
DO NOT
allow untrained persons to use the gauge.
WARNING!
When setting front-end alignment on commercial vehicles never make adjustments to drop arms or
interconnecting links. Doing so could result in serious tyre, wheel and steering problems.
any alignment changes deemed necessary as a result of using this equipment must be made strictly in accordance with the
vehicle manufacturer’s recommendations.
WARNING!
The warnings, cautions and instructions referred to in this manual cannot cover all possible conditions
and situations that may occur. It must be understood that common sense and caution are factors which cannot be
built into this product, but must be applied by the operator.
camber gauge graduation: ................+5° to -5°
castor gauge graduation: ................+11° to -3°
King Pin gauge graduation:....................0 to 14
magnetic Plate Ø: .....................................85mm
ga450 Issue no: 1 - 28/10/08
