Sealey G2000I.V2 Instructions Manual Download Page 3

G2000i.V2 | issue 1 05/09/16

Original Language Version

© Jack sealey limited

 

capacity. to switch the generator back on , press the dc protector button to “on”, direct current will resume.

 

Reduce the load of the connected device below the specified rating output of the generator if the DC protector turns off again, Stop  

 

using the device  and contact authorized stockist.

5.6.    

economy control switch (ecs)

 

When the ecs switch is “on” the economy control unit controls the engine speed according to the connected load. the results are  

 

better fuel consumption and less noise.

 

When the ECS switch is “OFF” the engine runs at the rated speed (4500rev/min) regardless of whether a load is connected or not.

 

note

:- the ecs must be “off” when using electrical devices that require a large starting current, such as a compressor or  

 

 

submersible pump.

5.7.    

fuel tank cap

 

turn the fuel tank cap counter clockwise to remove

 

The fuel tank cap is provided with an air vent knob to allow fuel flow. The air vent knob must be turned to “ON” This will allow fuel to  

 

flow to the carburettor and the engine to run. When the engine is not in use turn the air vent knob to “OFF” to stop fuel flow.

5.8.    

ground (earth) terminal

 

When the electrical device is earthed, the generator must always be earthed.

6.  operatIon

6.1.    

engine oil

 

‰

  

WarnIng!

 the generator has been shipped without engine oil. 

Do not

 start the engine until it has been filled with sufficient engine  

 oil.

 

Recommended engine oil................................................SAE SJ 15W-40

 

recommended engine oil grade................ APi service se type or higher

 Quantity...........................................................................................0.35ltr

6.1.1.   

Place the generator on a level surface.

6.1.2. 

  

Remove the screws fig.2.1and then remove cover fig.2.2.

6.1.3. 

  

Remove oil filler cap.

6.1.4.   

Fill with the specified amount of the recommended engine oil replace and tighten the oil filler cap.

6.1.5.   

replace the cover and tighten the screws.

 

6.2.    

fuel

 

   Danger: 

The Fuel is highly flammable.

 

8

  

Do not

 overfill the fuel tank, as it might overflow

 

when the fuel warms up and expands.

 

9

   use only unleaded petrol. the use of leaded petrol will

 

cause severe damage to internal engine parts.

 

‰

  

WarnIng!

 the generator should be kept in an upright position 

 

when fuel is in the tank.

 

recommended fuel....................................unleaded Petrol

 

Fuel Tank Capacity.....................................................4.0ltr.

6.2.1. 

  

To fill tank remove fuel tank cap and pour fuel into the tank

 

up to the red line inside the filler tube fig.3.

 

Maximum fuel level is shown in fig.4.

6.3.      

starting the engine

6.3.1. 

  

Turn the ECS switch (Bkack) to “OFF” fig.5.

6.3.2. 

  

Turn the air vent knob to “ON” fig.6.

   fig.2

   fig.3

   fig.5

   fig.4

   fig.6

Summary of Contents for G2000I.V2








Reviews: