Original Language Version
© Jack Sealey Limited
CP20VPHT Issue 1 22/10/21
6. MAINTENANCE
WARNING!
Remove battery before attempting any cleaning, maintaining or
storing the device.
6.1.
CLEANING
6.1.1.
Keep all safety devices, air vents and the motor housing free of dirt and dust as far
as possible. Wipe the equipment with a clean cloth or blow it with compressed air
at low pressure.
6.1.2.
Clean the equipment immediately after use.
6.1.3.
Clean the equipment regularly with a moist cloth and some soft soap.
8
DO NOT
use cleaning agents or solvents; these could attack the plastic parts of
the equipment.
6.1.4.
Ensure that no water can seep into the device. The ingress of water into an electric
tool increases the risk of an electric shock.
6.1.5.
Remove deposits from the guard hood with a brush.
6.2.
MAINTENANCE
6.2.1.
Before operation or once per hour during operation, apply low-viscosity oil
(machine oil, or spray-type lubricating oil) to the shear blades (fig.11).
6.2.2.
After operation, remove dust from both sides of the shear blades with a wired
brush, wipe it off with a cloth and then apply low-viscosity oil (machine oil, or spray-
type lubricating oil) to the shear blades (fig.12).
6.2.3.
There are no parts inside the equipment which require additional maintenance.
6.3.
STORAGE
6.3.1.
Store the trimmer with blade guard fitted (fig.10).
6.4.
CARBON BRUSHES
6.4.1.
In case of excessive sparking, have the carbon brushes checked only by a qualified electrician.
WARNING!
The carbon brushes should not be replaced by anyone but a qualified electrician.
7. TROUBLESHOOTING
PROBLEM
CAUSE
SOLUTION
Motor does not run.
Battery is not installed.
Install the battery.
Battery problem (low charge).
Recharge the battery. If recharging is not effective, replace battery.
The drive system does not work
correctly.
Ask your local authorized Sealey service center for repair.
Motor stops running after
minimal use.
Battery charge level is low.
Recharge the battery. If recharging is not effective, replace battery.
Overheating.
Stop using of tool to allow it to cool down.
Tool does not reach
maximum RPM.
Battery is installed incorrectly.
Install the battery correctly.
Battery power drops during use.
Recharge the battery. If recharging is not effective, replace battery.
The drive system does not work
correctly.
Ask your local authorized Sealey service center for repair.
Shear blades do not move
STOP IMMEDIATELY
Inappropriate angle of shear blades.
Make sure that the head is properly fixed in the operational angle.
Foreign objects are caught between the
shearblades.
Switch off the tool and remove the battery, and then remove the
foreign objects using tools such as pliers.
The drive system does not work
correctly.
Ask your local authorized service centre for repair.
Abnormal vibration
STOP IMMEDIATELY
Shear blades are broken, bent or worn. Replace the shear blades.
The drive system does not work
correctly.
Ask your local authorized Sealey service centre for repair.
Shear blades and motor
cannot stop:
REMOVE THE BATTERY
IMMEDIATELY!
Electric malfunction.
Remove the battery and ask authorized Sealey service centre for
repair.
fig.11
fig.12