NOTE:
It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
iMPortant:
no liability is accepted for incorrect use of this product.
Warranty:
Guarantee is 12 months from purchase date, proof of which will be required for any claim.
sole uK distributor, sealey Group.
Kempson Way, suffolk Business Park,
Bury st. edmunds, suffolk.
iP32 7Ar
www.sealey.co.uk
01284 757500
01284 703534
Bt102.V2 | issue 1 24/01/17
Original Language Version
© Jack sealey limited
environmental Protection
recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
Weee regulations
dispose of this product at the end of its working life in compliance with the eu directive on
Waste electrical and electronic equipment (Weee). When the product is no longer required, it must be disposed
of in an environmentally protective way. contact your local solid waste authority for recycling information.
if voltage reading is less than 13.4V, the yellow led will illuminate = charging system fault, check connections, wiring, drive belt
tension and alternator.
4.4.4.
turn off engine and remove clamps from battery.
5. troUbleshooting
5.1.
if screen shows Hi: Voltage over 15V. tester will not operate in this condition, ensure battery being tested is 12V.
5.2.
if screen shows lo: Voltage is under 7V. tester will not operate in this condition, recharge the battery and repeat test, if still reading lo,
replace battery.
5.3.
if the screen is blank: ensure the clamps are connected correctly, clean battery posts if required. the voltage of the battery is too low to
operate the tester, recharge the battery and repeat test, if screen is still blank, replace battery.
If the screen flickers or shows _ _ _ _: The voltage is unstable, check all connections and recharge battery if required, retest if display
remains as before replace battery.
