CASSUTT 3M RACER.
Instruction Manual
16
Remove covering.
INSTALLING THE HORIZONTAL
STABILIZER.
Draw center line.
Required Parts
•
Fuselage assembly
•
Tail Set(Rudder and Elevator)
Required Tools and Adhesives
•
Ruler,Pen,Knife
•
30-mminute epoxy
4) With the stabilizer held firmly in place,
use a pen and draw lines onto the stabilizer
where it and the fuselage sides meet. Do this
on both the right and left sides and top and
bottom of the stabilizer.
3) Slide the stabilizer into place in the pre-
cut slot in the rear of the fuselage. The stabi-
lizer should be pushed firmly against the front
of the slot.
1) Using a ruler and a pen, locate the
centerline of the horizontal stabilizer, at the trail-
ing edge, and place a mark. Use a triangle
and extend this mark, from back to front,
across the top of the stabilizer. Also extend
this mark down the back of the trailing edge of
the stabilizer.
2) Using a modeling knife, carefully remove
the covering at mounting slot of horizontal sta-
bilizer ( both side of fuselage).
5) Remove the stabilizer. Using the lines
you just drew as a guide, carefully remove the
covering from between them using a model-
ing knife.
Aileron
.
Wing
.
Wing
.
Repeat the procedure for the other aileron servo.
Aileron
.