www.seagullmodels.com
13
The propeller should not touch any part
of the spinner cone. If it does, use a
sharp modeling knife and carefully trim away
the spinner cone where the propeller comes
in contact with it.
ELECTRIC POWER CONVERSION.
SPINNER INSTALLATION.
Install the spinner backplate, propeller and
spinner cone.
Required Parts
•
Fuselage assembly
•
Fiberglass cowlinh
•
Spinner assembly
•
M3x10mm machine screw(4)
Required Tools and Adhesives
•
Phillips screwdrive
Servos.
Small weight.
Thread.
INSTALLING THE AILERON.
Required Parts
•
Wing assembly(left and right)
•
Servo with hardware (2)
•
M2x12mm machine screw(8)
Required Tools and Adhesives
•
Phillips screwdrive
•
30-mminute epoxy
String.
Small weight.
1) Using a small weight (
Weighted fuel pick-up
works well
) and string, feed the string through
the wing as indicated.
2) Place the servo between the mounting
blocks and space it from the hatch. Use a pencil
to mark the mounting hole locations on the
blocks.
Because the size of servos differ, you
may need to adjust the size of the precut open-
ing in the mount. The notch in the sides of
the mount allow the servo lead to pass through.
Machine Screw M3x10mm
3) Install the muffler and muffler extension
onto the engine and make the cutout in the
cowl for muffler clearance. Connect the fuel
and pressure lines to the carburetor, muffler
and fuel filler valve. Secure the cowl to fuse-
lage using the 3x10mm screws to tighten the
screws.
Needle valve.