WWW.SEAGULLMODELS.COM
27
.
INSTALLATION PILOT AND CANOPY.
1) Locate items necessary to install pilot,
seats.
2) A scale pilot is included with this ARF.
The Seagull Pilot included fitting well to
the cockpit. (or you can order others scale
pilot figures made by Seagull factory.
They are available at Seagull distributors.)
If you are going to install a pilot figure,
please use a sanding bar to sand the base
of the figure so that it is flat.
3) Position the pilot figure on the canopy
floor as shown. Use epoxy to glue the base
of the pilot figure to the cockpit floor,
please see pictures as shown.
Glue the cockpit instrument panel in
place with C/A glue, please see pictures
as shown.
Epoxy.
150mm
4) Position the canopy onto the fuselage.
Trace around the canopy and onto the
fu¬selage using a felt-tipped pen. Care-
fully cut and remove covering mate-
rial from the fusealge where the canopy
makes contact, exposing the bare wood.
The permanently glue the canopy in place
with epoxy glue or special “canopy glue”.
Epoxy.
The decals are sticky-back type. Most
are factory die-cut to shape. If you want
to trim the edges closer, use a sharp #11
hobby knife. Small decals can be applied
by simply removing the paper backing
sheet, and then lay the decal in position.
APPLY THE DECALS.
