TURBO RAVEN.
Instruction Manual
24
MOUNTING THE TAIL WHEEL.
See pictures below.
M3 x 12mm.
2
1
M3 x 12mm.
1.
2.
2
1
8) Install servos arm to servos. Notice the
position of the servo arms on the servos. See
picture below.
3) Secure the tail wheel bracket in place
using two 3mm x 12mm wood screws. Be
careful not to overtighten the screws.
1) Set the tail wheel assembly in place on
the plywood plate. The pivot point of the tail
wheel wire should be even with the rudder
hinge line and the tail wheel bracket should
be centered on the plywood plate.
2) Using a pen, mark the locations of the
two mounting screws. Remove the tail wheel
bracket and drill 1mm pilot holes at the loca-
tions marked.
Cut.
INSTALLTION PILOT.
Elevator.
Rudder.
1) A scale pilot is included with this ARF. The
Seagull Pilot included fitting well to the cockpit.
(or you can order others scale pilot figures
made by Seagull factory. They are available at
Seagull distributors.)
If you are going to install a pilot figure, please
use a sanding bar to sand the base of the figure
so that it is flat.
2) Position the pilot figure on the canopy floor
as show. Locate the oval shaped on the canopy
floor and remove the covering. Use epoxy to
glue this into the base of the pilot figure, please
see pictures as shown.
