WWW.SEAGULLMODELS.COM
99
6) Slide the threaded end of the axle through
the hole in the bottom of the landing gear leg.
Use a washer and locknut to tighten the axle
to the landing gear. Make sure to use thread-
lock on the nut so it won’t vibrate loose in
flight as shown.
7) Tighten the setcrews using a hex wrench
to secure the collars on the axle over the flat
spot to retain the wheel as shown.
Repeat steps as above to attach remaining
wheel pants to the landing gear.
INSTALLING THE FUSELAGE SERVOS.
Because the size of servos differ, you
may need to adjust the size of the precut opening
in the mount. The notch in the sides of the
mount allow the servo lead to pass through.
1) Install the rubber grommets and brass
collets onto the throttle servo. Test fit the
servo into the aileron servo mount.
2) Secure the servos with the screws provid-
ed with your radio system.
Wheel collar.
Wheel.
M3
Axle.
Washer.
M3
Wheel.
Wheel collar.
Washer.
nut.--
Lite-Plywood
block.
Wheel Pant.
C/A glue.
M3.
Axle.
Throttle
Rudder
Elevator
