WWW.SEAGULLMODELS.COM
23
INSTALLATION PILOT AND CANOPY.
1) Locate items necessary to install pilot and
canopy.
2) A scale pilot is included with this ARF.
The Seagull Pilot included fitting well
to the cockpit. (or you can order others
scale pilot figures made by Seagull fac-
tory. They are available at Seagull factory.
They are available at Seagull distributors.)
If you are going to install a pilot figure, please
use a sanding bar to sand the base of the fig-
ure so that it is flat.
4) Position the canopy onto the fuselage.
Trace around the canopy and onto the fuse-
lage using a felt-tipped pen.
Epoxy
8mm
3) Position the pilot figure on the canopy
floor as show. Locate the oval shaped on the
canopy floor and remove the covering. Use
epoxy to glue this into the base of the pilot
figure and glue the cockpit panel in place
with C/A glue, please see pictures as shown.
APPLY THE DECALS.
1) If all the decals are precut and ready to
stick. Please be certain the model is clean and
free from oily fingerprints and dust. Position
decal on the model where desired, using the
photos on the box and aid in their location.
2) If all the decals are not precut, please use
scissors or a sharp hobby knife to cut the
decals from the sheet. Please be c ertain the
model is clean and free from oily fingerprints
and dust. Position decal on the model where
desired, using the photos on the box and aid
in their location.
- Apply a bead of canopy glue around the in-
side edge of the canopy. Position the canopy
onto the hatch. Use tape to hold the canopy
secure until the glue fully cures.
.
INSTALLING THE BATTERY-
RECEIVER.
1) Plug the five servo leads and the switch
lead into the receiver. Plug the battery pack
lead into the switch also.
2) Wrap the receiver and battery pack in the
protective foam rubber to protect them from
vibration.
