Cessna 208 Grand Caravan 85 inch wingspan 35-40cc
Instruction Manual.
32
Slide the vertical stabilizer into the slot in
the top of the fuselage. he rear edge of the
stabilizer should be lush with the rear edge
of the fuselage and the lower rudder hinge
should engage the precut hinge slot in the
lower fuselage. he bottom edge of the stabi-
lizer should also be irmly pushed against the
top of the horizontal stabilizer.
.
Slide the vertical stabilizer back inplace.
Using a triangle, check to ensure that the
vertical stabilizer is aligned 90º to the
horizontal stabilizer.
While holding the vertical stabilizer
irmly in place, use a pen and draw a
line on eachside of the vertical stabilizer
where it meets the top of the fuselage.
90º
Vertical
Stabilizer.
Horizontal
Stabilizer.
Epoxy.
When you are sure that everything is
aligned correctly, mix up a generous
amount of Flash 30 Minute Epoxy. Ap-
ply a thin layer to the mounting slot
and to bottom of the vertical stabilizer
mounting area. Apply epoxy to the bot-
tom and top edges of the iller block and
to the lower hinge also. Set the stabilizer
in place and realign. Double check all of
your measurements once more before
the epoxy cures. Hold the stabilizer in
place with T-pins or masking tape and
remove any excess epoxy using a paper
towel and rubbing alcohol. Allow the
epoxy to fully cure before proceeding.
6
.
7
.
4
.
5
.
C/A glue.
Hinge.
8
.
9
.
Summary of Contents for SEA 362
