Seagull Models SEA 358, Assembly Manual

Page: 6 / 64

1/3 ScaleMorane Saulnier AI Instruction Manual.
6
Before the epoxy fully cures, remove
the tape from around the control horn.
his will allow the epoxy to low around
the control horn, creating a small ilet
between the control horn and surface for
a iished look and secure bond.
INSTALLING THE AILERON SERVOS
Because the size of servos difer, you
may need to adjust the size of the precut
opening in the mount. he notch in the
sides of the mount allow the servo lead to
pass through.
Place the servo between the mounting
blocks and space it from the hatch. Use a
pencil to mark the mounting hole loca-
tions on the blocks.
Use drill bit in a pin vise to drill the
mouting holes in the blocks.
7 .
6 .
1 .
2 .
3 .
Epoxy
20.0
Minimum servo spec.
Torque : 6.0V: 157.00 oz-in (11.31 kg-cm)
7.4V: 179.00 oz-in (12.89 kg-cm)