Seagull Models JU-87 STUKA, Assembly Manual

Page: 27 / 42

27
INSTALL RUDDER CONTROL HORN.
Repeat steps to install the rudder control
horn as same as steps done for elevator.
Rudder fiberglass control horn.
Epoxy.
Fiberglass control horn.
INSTALLING THE HORIZONTAL
STABILIZER.
1) Using a ruler and a pen, locate the
centerline of the horizontal stabilizer, at
the trailing edge, and place a mark. Use a
triangle and extend this mark, from back
to front, across the top of the stabilizer.
Also extend this mark down the back of
the trailing edge of the stabilizer.
2) Using a modeling knife, carefully re-
move the covering at mounting slot of
horizontal stabilizer ( both side of fuse-
lage).
Cut.
Draw center line
3) Slide the stabilizer into place in the
precut slot in the rear of the fuselage.
The stabilizer should be pushed firmly
against the front of the slot.