AT 6 - TEXAN.
Instruction Manual.
17
3) Install the muffler and muffler extension
onto the engine and make the cutout in the
cowl for muffler clearance. Connect the fuel
and pressure lines to the carburetor, muffler
and fuel filler valve. Secure the cowl to fuse-
lage using the 3mmx12mm screws.
1)Slide the fiberglass cowl over the engine
and line up the back edge of the cowl with the
marks you made on the fuselage.
2) While keeping the back edge of the
cowl flush with the marks, align the front of
the cowl with the crankshaft of the engine. The
front of the cowl should be positioned so the
crankshaft is in
nearly
the middle of the cowl
opening. Use the spinner backplate as a guide.
Hold the cowl firmly in place using pieces of
masking tape.
Because of the size of the cowl, it may
be necessary to use a needle valve extension
for the high speed needle valve. Make this out
of sufficient length 1.5mm wire and install it
into the end of the needle valve. Secure the
wire in place by tightening the set screw in the
side of the needle valve.
COWLING.
Trim and cut.
Trim and cut.
Pushrod wire.
