2.2
The ATA interface connector
The drive uses a standard 40-pin interface connector with 2 rows of 20
male pins. Pin 20 is removed. The connector is shown in Figure 2.
For the mating connector, use a 40-pin, nonshielded connector with 2
rows of 20 female contacts. We recommend the following part numbers:
AMP
499496
Berg Electronics
66900-040
2.3
Power connector
The drive comes with a standard 4-pin power connector. It is also
available with a standard 3-pin power connector.
2.4
Master/slave jumper block
Figure 3 shows the location of the master/slave jumper block and shows
how to install the jumpers for various configurations. The jumper block
accepts 2-mm (0.079-inch) jumpers. A spare jumper is attached to the
jumper block. If you need additional jumpers, use Seagate part number
10562-001 or an equivalent.
Caution. If you use a jumper that is not the correct size, you may damage
the jumper block and the jumper. Use the jumpers supplied
with the drive.
0.70 ± 0.010
1.90
0.025
± 0.002
0.100 typ
0.230 ± 0.003
2.00
0.235 ± 0.025
0.160
0.070 ± 0.010
0.100 ± 0.010
0.025 ± 0.002
Dimensions are in inches
Figure 2. The drive interface connector
12
Medalist XE Family Product Manual, Rev. B