Seagate ST15150DC, Product Manual

Page: 65 / 102

ST15150N/ND/W/WD/WC/DC Product Manual, Rev. D 55
10.2 Synchronized spindles interface
The synchronized spindles interface (SSI) allows several drives operating
from the same host to operate their spindles at a synchronized rotational rate.
The system operation is described in Section 5.7.
10.2.1 Electrical description
The electrical interface consists of one digital TTL reference index signal and
ground. The reference index signal (SSREF+) is an output if the drive is
configured as a master and is an input otherwise. The reference index signal
is connected from drive to drive in a daisy-chain fashion as shown in Figure 4.
10.2.1.1 Drivers and receivers
Figure 25 shows a diagram of the driver/receiver circuit. The driver circuits
have the following electrical specifications:
Negated (false) 0.V to +0.4V @ I = –24 mA (max)
Asserted (true) +2.24V to +5.25V @ I = +250 µA
Driver Receiver
2.21K Ohm
SSREF +
GND
Main PWA
J4 - 1 (N/ND Drives)
J5 - 11 (W/WD Drives)
+5V
J4 - 2 (N/ND Drives)
J5 - 12 (W/WD Drives)
Open
Collector
ST15150WC/DC drives use J04 pin 6 for synchronizing spindles.
Figure 25. SCSI reference index signal driver/receiver combination