SeaDoo 105A, Manual

Page: 276 / 391

Section 09 PROPULSION
Subsection 02 (DRIVE SYSTEM)
F05I08A
1 2
TYPICAL
1. Alignment tool
2. Seal carrier
If alignment tool does not slide easily through seal
carrier, perform the alignment as follows.
For vertical alignment, loosen damping support
nuts
no. 27 and move the support no. 28 up and
down as necessary.
F00B25A
2
1
TYPICAL
1. Damping support
2. Loosen nuts
When done, ensure to apply Loctite 243 (blue)
(P/N 293 800 060) on nut threads then torque nuts
to 22 N•m (16 lbf•ft) in a criss-cross sequence.
For horizontal alignment, loosen shaft support
screws
no. 29 and move the support no. 15
sideways as necessary.
2
1
F00B26A
TYPICAL
1. Shaft support
2. Loosen screws on both sides
When done, ensure to apply Loctite 243 (blue)
(P/N 293 800 060) on screw threads then torque
screws to 22 N•m (16 lbf•ft) in a criss-cross se-
quence.
NOTE: Ensure the alignment washers are still
loose.
Check engine alignment. Refer to ENGINE sec-
tion.
Front Drive Shaft Coupler and Damper
Make sure to install dampers no. 30 into drive
shaft coupler at both ends.
2
F08I07A
1
TYPICAL — SAME COUPLER AND DAMPER AT BOTH ENDS
1. Damper
2. Drive shaft coupler
smr2005-063
265
www.SeaDooManuals.net