SeaDoo 105A, Manual

Page: 342 / 391

Section 11 HULL/BODY
Subsection 01 (GTI SERIES)
Inside
For the interior repair, you can grind more. This
will allow for more fiberglass material which will
strengthen the area. If the fracture opening is too
large after surface preparation, you may need a
backing support to cover the opening. Cut alter-
nating pieces of fiberglass mat and cloth in over-
lapping sizes.
PATCHING THE REPAIR AREA
Outside
The outside should be done first. Wipe clean the
area with acetone on a cloth, then mask off area.
For a small crack use an epoxy filler in the same
way you would use gelcoat repair putty. When
laying up a larger area you will use mat, cloth and
fiberglass resin and catalyst. Use a clean contain-
er to mix the resin, mix only what you will need.
Follow the recommended catalyst ratio.
Using a clean paintbrush, brush the mixed resin on
the surface. Place the smallest piece of mat over
the fracture and then wet out the mat. Follow
with the remaining pieces of mat and final layer
of cloth. While wetting the pieces make sure you
work the air bubbles out and saturate all the pieces
evenly. Try to work quickly, you may only have
15 or 20 minutes. You may clean the brush with
acetone.
Wait until the repair has hardened before moving
on to the interior repair. If the size of the opening
is too large for the pieces to maintain the proper
shape, you will have to use a backing support. It
is a shaped piece of cardboard that fits flush to the
interior surface and has a plastic layer on the repair
side. It is held in place by tape or a support.
Inside
Wipe down the area with acetone on a cloth. Ap-
ply the same procedure as for outside repair when
laminating the alternating pieces of fiberglass ma-
terial. If a backing support was used, remove it
before starting the repair. After the area has hard-
ened, remove sharp edges of material from sur-
face. If required paint the surface.
SANDING
Outside
This surface will have to be prepared for applica-
tion of gelcoat. The size of the area will deter-
mine the gelcoating procedure to be used. Refer
to the REPAIR PROCEDURE FOR MINOR GEL-
COAT FRACTURES.
BUFFING AND WAXING
Refer to the BUFFING AND WAXING FOR MINOR
GELCOAT FRACTURES.
TOOLS AND MATERIALS LIST
Tools
– safety glasses – putty knife
– air mask – plastic film
– white cloths – stirring stick
– sanding block – buffing pad
– scissors – heavy-duty polisher
– power sander – paint brush
– spray gun – plastic squeegee
– cover sheets (for
Sea-Doo)
– plastic container
(mixing)
Materials
– fiberglass mat – gelcoat putty
– fiberglass cloth – liquid gelcoat
– polyester resin – acetone
– cardboard – epoxy filler
– masking tape – wax
– cabosil – fine compound (white)
– 24-grit sanding disks –
– sandpaper
(100-grit, 220-grit,
320-grit, 400-grit,
600-grit, 1000-grit)
medium compound
(white)
332
smr2005-069
www.SeaDooManuals.net