
22
REPLACING THE BATTERY
•
WARNING!
Batteries should always be replaced by an authorized SEAC Center,
because this is a delicate operation with a high probability of subsequent
flooding of the Driver if performed by inexpert personnel.
SEAC declines all responsibility for problems resulting from changing the
battery.
•
WARNING!
When replacing the CR2032 battery, it's a good idea to also replace the
O-ring of the battery cap an original SEAC O-ring.
a) Unscrew and remove the three screws from the battery compartment.
b) Insert a small flathead screwdriver in the screw seat closest to the strap
and prize off the lid.
c) Again using the small flathead screwdriver, prize up the battery from its
housing and remove it.
d) Insert the new battery, snapping it into its housing and making sure that
the “+” polarity sign is facing outward.
e) Remove the old O-ring from the housing in the metal cover and replace it
with the new one. Make sure that the O-Ring is not damaged, and once
inserted make sure it isn't twisted at any point.
f) Position the cover on the Driver case, and press it evenly downward.
Make sure that in the area around the screws, the cover is flush with the
case.
g) Keep the cover pressed down on the Driver case while replacing the
three screws. Although the three screws are screwed through metal
inserts fixed in the case, we recommend not tightening with excessive
force to reduce the risk of stripping. The recommended torque is 12
Ncm. The O-ring seal on the battery compartment is radial, so excessive
closing force on the compartment screws is not necessary.
NOTE
Do not dispose of used batteries in the environment or discard them as
ordinary waste; we recommend using special battery disposal services.
Summary of Contents for DRIVER
Page 1: ...DRIVER www seacsub com FREEDIVING COMPUTER ...
Page 27: ...DRIVER 27 ...