The computer will not switch to
dive
mode.
•
If none of the previous apply, there may be a
malfunction.
•
Send the dive computer to the Seac Diving Pro s.r.l
for repair.
The
AQUALAB
dive computer does
not return to
surface mode
after a
dive.
•
This occurs when the water detection switch area is
still wet.
Use a soft dry cloth to dry off the computer
completely.
The dive computer switched to
surface mode
(surface and
desaturation time) even though no
switches were operated.
•
A sudden change in altitude rank may cause the
dive computer to start calculating residual nitrogen.
•
If you start diving when the computer is set this
way, the dive will be considered part of a series of
dives.
Nothing happens when I try to
operate a switch.
•
If this occurs after a dive, it may be because the
water detection switch area is still wet.
Wipe it dry and try again.
•
If the above does not apply, there may be a
malfunction.
•
Send the dive computer to the Seac Diving Pro
s.r.l for repair.
In
dive plan mode
, the no
decompression limit is shown as a
bar graph display.
“ - - -“
•
This occurs when an
out of measurement range
warning
has been output.
The computer will reset itself automatically after
48 hours.
•
It may also occur when the altitude measurement
exceeds 19,685 feet (6,000 meters), which causes
the altitude rank symbols to
“E”
.
The display will return to normal when the altitude
measurement is again below 19,685 feet (6,000
meters).
•
This is displayed when the altitude rank converts to
a depth value that exceeds the maximum depth for
NITROX diving.
Change the altitude rank setting to check this.
The altitude mark symbols
"E"
when the dive computer is in
surface mode
.
•
This occurs when the altitude measurement
exceeds 6,000 meters.
The display will return to normal when the altitude
measurement is again below 19,685 feet (6,000
meters).
The dive computer switches to
dive
mode
when at the surface.
•
This can occur when there is a sudden change in air
pressure (such as in an airplane) or when the water
detection switch is wet.
•
Avoid touching the switch and keep it dry.
Wipe off the water detection switch and wait about
ten minutes.
The display should then change to
surface mode
.
35
Summary of Contents for AQUALAB
Page 17: ...Decompression stop violation warning Ascent rate warning Maximum depth warning 16 ...
Page 18: ...Oxygen toxicity exposure level warning Out of measurement range warning 17 ...
Page 22: ...Dive Mode No decompression mode Decompression mode While switch A is pressed 21 ...
Page 38: ...37 ...
