Fig. 26
FLIPPER
25
PERIODICAL MAINTENANCE
Grease the moving parts
(Articulated arm, release, etc..)
Check the functioning of the release
Check the lock of the screws
Check the wear of the devices in movement
Check the integrity of the connected cables
Annual
Annual
Annual
Annual
Annual
RISK EXAMINATION
The points pointed by arrows in Fig. 26 are potentially
dangerous. The installer must take a close risk examination to
prevent crushing, conveying, cutting, grappling, trapping so to
guarantee a safe installation for people, things and animals
(
).
Re. Laws in force in the country where the installation has been
made
DECLARATION OF CONFORMITY
SEA declares under its responsibility that the products
FLIPPER
meets the essential requisites provided for by the following European Directive and following changes:
89/392/CEE (Machine Directive)
89/336/CEE (Electromagnetic Compatibility Directive)
73/23/CEE (Low Tension Directive)
SAFETY PRECAUTIONS:
All electrical work should conform to current regulations. A 16 A 0,030 A differential switch must be incorporated into the source
of the operators main electrical supply and the entire system properly earth bonded. Always run mains carrying cables in
separate ducts to low voltage control cables to prevent mains interference.
INTENDED USE:
FLIPPER operator has been designed to be used only for the automation of swing gates.
SPARE PARTS:
To obtain spare parts contact:
SEA S.r.l. - Zona Ind.le S.Atto, 64020 S. Nicolò a Tordino - Teramo - ITALIA
SAFETY AND ENVIRONMENTAL COMPATIBILITY:
Don’t waste product packing materials and/or circuits.
When being transported this product must be properly packaged and handled with care.
WARRANTY
The warranty for the operator FLIPPER is of 24 months starting from the date printed on the product. The product will be
accepted under guaranty if it does not present damages due to improprer use or to any kind of modification or changement.
MAINTENANCE AND OUT OF SERVICE:
The decommission and maintenance of FLIPPER must only be carried out by specialised and authorised personnel.
NOTE: THE MANUFACTURER CAN NOT BE DEEMED RESPONSIBLE FOR ANY DAMAGE OR INJURY CAUSED BY
IMPROPER USE OF THIS PRODUCT.
SEA
reserves the right to do changes or variations that may be necessary to its products with no obligation to notice.
FITTING AND CONNECTION INSTRUCTIONS
ENGLISH
Sistemi Elettronici
di Apertura Porte e Cancelli
International registered trademark n. 804888
®
REV 02 - 03/2009
