4. INSTALLATION OF THE OPERATOR
4.1.
Insert manually the operator
into the
carrying box (Fig. 15)
also insert the splined shaft of the operator into the splined bush
of the box and fix the operator with the special screws as in Fig.
17.
4.2.
Carry out the electrical connections to the control unit as
described in the instructions supplied with SEA control unit.
After ending all the operations in the installation of the above
mentioned carrying box, of the gate and the operator, try to do
some moves slowly by hand verifying that there are not irregular
frictions and that the movement is uniform for the whole range.
Notice:
To do this last operation, release the operator as
described in the next paragraph.
5. MOTOR RELEASE SYSTEM
5.1. To release act as follows:
-Turn the release screw with the screwdirver about 180° ca. in
anti- clockwise direction (Fig. 18).
5.2. To stop again act as follows:
-Turn the release screw with the screwdriver into clockwise
direction until it stops.
ENGLISH
6. MOUNTING OF THE RELEASE
For the Compact there are foreseen two types of release:
RELEASE (with personalised key) and RELEASE PLUS
(with DIN key).
RELEASE
6.1.
Grease the hinge (A) and mount the release system under
the leaf device using the 4 furnished screws (Fig. 19)
RELEASE PLUS
6.2.
Grease the hinge (A) and mount the release system under
the leaf device using the 5 furnished screws (Fig. 20).
67410850
Sistemi Elettronici
di Apertura Porte e Cancelli
International registered trademark n. 804888
®
N.B.
: It is advisable to weld the crank with the crank shaft after
having also installed the Compact, to use the whole available run
and the point of beginning of the desired slowdown (version with
hydraulic slowdown).
Before welding, make sure that one of the level of the crank shaft
corresponds with a side of the crank (see fig.16 and 17) to
guarantee the maximum angle with the mechanical stops Kit.
N.B.
: If the Compact is not installed immediately but in a second
time, it is recommended to weld the crank shaft and the crank
during the installation of the Compact.
REV 04 - 01/2010
13
Fig. 15
Fig. 17
1
2
Fig. 16
Fig. 19
A
Release
Fig. 18
Lock
Release
