Sea Tel 9497B-21, Installation And Operation Manual, Page: 30 / 104

Installation 9497B-21 C/Ku-Band TVRO
4-12
4.5.5.
If a marine air conditioner was purchased with t your system;
Installing the Marine Air Conditioner
8. Set the marine air conditioner on the base pan aligning the vents in the bottom of the air
conditioner to the cutouts in the basepan (refer to drawing 123496).
9. Install the air, per drawing 122508, using the hardware and isolators provided in the installation kit,
10. Install the strain reliefs as required to install AC power cable to the air conditioner.
4.5.6.
Refer to the General Assembly drawing for your system and the procedure below.
Sub-assemble the Antenna Pedestal
1. Install the Base Stand, or
Mounting Spider, onto the
Base Pan using the hardware
provided. Apply Loctite to
and tighten the mounting
bolts.
Note:
As an alternative, the stand can
be mounted to, and lifted with, the
pedestal in step 12 below.
2. Lift the dish up and install it
onto the reflector mounting
brace using the hardware
provided. Assure that the
orientation of the reflector is
correct. Apply Loctite to and
tighten the mounting bolts.
3. Tie the dish down with web
straps to hold it at its lowest
elevation. Tie the straps
through the reflector mount
brace and around the
pedestal.