Sea Tel 6012-71 C-BAND, Installation Manual

Page: 54 / 101

6012-71 Installation Manual Quick Start Operation
10-2
3. Not finding a signal greater than
Threshold, the bar graph will stay red
and the antenna will reach the end of
the prescribed search pattern.
4. The antenna will retarget and the
cycle will repeat (Search Delay
timeout, conduct search pattern
followed by retarget).
5. Check Latitude, Longitude and
Heading. These should be correct, but
may be updated if necessary.
6. Access the System Status screen.
7. Find the Latitude, Longitude (under
Ship) and Heading (in the banner)
displayed values. If they are correct
skip to step 12.
8. If the Latitude & Longitude values are
not correct, access the
Communication Interfaces screen and
enter the ships Latitude & Longitude
position in the fields provided.
9. If the Heading value is not correct,
enter the correct value in the lower
right field of the Communication
Interfaces screen. If the system is set
for NMEA or 1:1 type, you will not be
able to enter a heading value.
10. Click Save.
11. Check for blockage (this is the MOST
common cause of not being able to
acquire the desired satellite).
12. Verify that the correct satellite is
selected.
13. Check cable connections to assure
that a cable has not been
disconnected.