Sea Recovery Ultra Whisper Compact 400, Owner'S Manual

Page: 22 / 120

20
Electronic Components
The System’s electronic components measure water quality, control the direction of Product Water flow, Start and
Stop the System, and contain the central electrical connection point. They also ensure only potable Product Water
passes into the Product Water Storage Tank.
1. Salinity Controller monitors the salt content of the product water via the Salinity Probe, and signals the 3-Way
Product Diversion Valve when Potable Water is being produced. The 3-Way Product Diversion Valve, Feed
Pump Motor, Remote Control, UV Sterilizer, and Soft Motor Starter are each governed by this Controller. This
enclosure also contains the high-voltage components of the system. It serves as the connection point for all
the electrical systems such as the motors, transducers, and valves.
2. Remote Controller*** allows for remote monitoring and controlling of the system.
3. Soft Start*** used only in AC (Alternating Current) Single Phase systems reduces by 40% the initial startup
amperage required to start the Feed Pump Motor and in turn allows a smaller sized KW generator to start
the system.
Plumbing Connections
1. Tube-Fitting Connections and Assembly:
a) Cut tube end square and clean.
b) Loosen nut on fitting three turns.
c) Wet the end of the tube and insert tube into fitting until it bottoms. Loosen nut completely and remove tube
with attached parts from body. Check to ensure that the O-ring is seated onto the tube under the spacer
(and not pinched into the body). Insert tube with attached parts into the body and tighten nut finger-tight.
2. Refer to the illustration below. Always allow slack in all tube and hose lines. Never cause the tube or hose to
immediately bend from the fitting. Allow the line to enter or leave from the fitting in a straight manner for several
inches to ensure proper connection, to relieve stress to the fitting and tube or hose, and to allow ease of
detachment and reattachment during maintenance or repair. If water lines are pulled tight causing them to bend
at the fitting, they will leak, allow air to enter, fail prematurely and/or break the fitting that they are attached to.
Ultra Whisper 400-600